I feel for you with the problems. I didn't spend much on what I made, only needed to get square tubing (already had 1" shaft, wheels and hubs). I just measured the frame, this one's 75" long (not counting tongue) and 24" wide. I was more interested in the width for wheel track than length. I conjured up this idea nearly 20 years ago with the need to get around in a thick woods, then haul nearly a half mile to the nearest road. The uprights might be handier if they were removable, I welded these on. In this picture I hauled the 2 wheel tractor a mile incl. along the railroad to a neighbor's. I made the cultivator on the 2 wh. tractor, I like it cause I can tip it back (wheels off the ground) and turn around on the spot. The box on the atv was a factory reject toolbox drawer I got at the local scrapyard.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.