Posted by JEFFCAT on October 01, 2012 at 15:36:27 from (220.127.116.11):
In Reply to: Concrete repair posted by Jimdril on September 28, 2012 at 15:06:17:
On patches like that you want to use stainless steel pins. you can buy stainless rod cheap enough at a metal supply place. cement NEVER stops curing! It will slowly eat at the steel. If you can sand blast the mate surface and build a little form to pour it should work. A stainless pin every 2 inches "use a cabide drill" should do it. When they repair hyways they have drill rigs that they use to dowl pin the concrete. It drills like 6 holes at the same time sideways into the main slab, and then they put in 1" steel pins. jeffcat
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.