Posted by old on September 27, 2012 at 09:05:59 from (184.108.40.206):
In Reply to: Bending Metal posted by Lucid on September 26, 2012 at 20:56:13:
A lot depends on what your bending and then what your doing with it. If say your bending round stock a simple pipe bender will do the job and it costs around $100. If your going to bend sheet metal the thin stuff a simple bender is made for that. Now if your going to bend the heavy stuff then you either need a big machine or an Ox/ac torch. I have bent a piece of flat stock that was 2 inches wide and 1 inch thick in my pipe bender and that came out well. Made a heavy duty clevis with it
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.