Depending on how much you wanna spend to make them round again. I"m sure there"s a weld shop or equipment shop around that does on site line boring. The boom will have to be disassembled hand welded or boreteched then the bores recut. I use to do it on large loaders and strip mining equipment. That was back in the late nineties I don"t have a clue what they charge now. Then it was 75 an hour. It also could be bored oversize and have bushings made to fit. I guess it all depends on how much you want to invest in repairing it verses what it"s worth.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.