Lanse, I graduated from Hobart in Feb.1969. When I went there Mig welding was just being developed. They called it Microwire Welding. I have been welding almost continously ever since. I have worked in coal fired power houses,on all types of coal and earthmoving equipment,chemical plants, textile plants, built water tanks, pipelines and just about anything you can imagine. I have been in business for myself for over 35 years and I basically owe it all to Hobart. If I hadn't gone there it is hard to say what I would have done in life. Welding is a hot dirty job, but it has it's rewards also. It feels pretty good to drive through a community and look over and say I built that water tank, that sign post, that handrailing around the veterans memorial, that truck bed, that set of entrance gates or whatever. Hobart will give you the skills you need. Study hard and Good Luck !!!Welding Man
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Looking 4 set 9 bolt hubs 3 1/8 inch to fit 60 to 4010 jd
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.