Posted by three4rd on April 25, 2012 at 16:24:37 from (72.92.62.5):
Hi,
I have an old Ajax jack (model 95632) It always worked great, but when I went to use it today I noticed that the piston was stuck all the way in. First I topped off the hydraulic oil, but that didn't do anything. It did take quite a bit of oil, but no evidence of leakage on the garage floor. I then removed the locking clip and took apart the spring assembly so that I could get at the piston.
The piston is really, really tight. I tried WD-40, some oil right into the cylinder, etc. You have to actually hammer the piston in and then you can get it to retract by hammering it the other way with a screwdriver - I thought if I do this a few times it would start to loosen up but no dice. Any thoughts on this? I've read about the need to sometimes replace the seals but I don't think this is the problem. If I close the valve and push the retracted piston in either with the handle or by hammering it in, the jack does go up and holds its position, then comes back down when opening the valve. So I'm thinking the problem is the piston itself. I've also read that if the piston IS indeed the problem, that there is not a whole lot that can be done. I'm not even sure if that piston unscrews from the rest of the jack - there is a big nut at the threads where it joins the body but it does not seem like it wants to turn.
Is there a way to fix this piston? I don't believe the seals are the problem since if I push the piston in with either the handle or by hand the jack does lift and maintains position, but the piston won't move back out unless forced to do so.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.