Posted by Bob on November 15, 2009 at 18:11:46 from (69.178.228.68):
In Reply to: Ford 8N Lift Control posted by CoreyV. on November 15, 2009 at 17:27:06:
Do you have the position control lever "up" (set for "position" rather than forward, which is "draft" mode?
There are 4 bolts that hold the lever assembly in place. With them slightly loosened, the assembly can be tapped back or forth, adjusting the range of the lift lever.
A worn cam follower pin or other internal problems could be causing you grief, as well.
For more help, post over at the "N"-specific Forum. Zane Sherman is the lift GURU over there. He has instructions as well as a jig for setting up the lift mechanism.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.