Tractor Pulling Discussion Board|
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by doug vose on April 17, 2002 at 19:54:45 from (22.214.171.124):
i didnt know whether i should put this question on the mower board or the puller board, so i put it on both.
I am going to start mower pulling, and i need some websites for information and i need to know what i should do to my mower. i have a Dynamark 18/43. it has an 18 horse briggs and stratton motor, twin cylinder. I am going to put dual carbs on it and dual straight pipes to resemble the exhaust of an International 1568. Any info on other mods i should do is appreciated.
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2014 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters