Posted by v8s10 on April 08, 2013 at 17:26:46 from (98.132.231.144):
hello im new to this website, ive made a few posts on here asking questions and have always gotten great responces and advice from you guys! thanks everyone! im in the proccess of building a motor for my tractor! ive got a farmall M motor bored out with 4 and 1/8 pistons and sleeves, there the high compresion step head pistons for a 450 like what you would buy from tisco.. ive got a brand new 450 lp head and lp manifold,petronix electronic ignition, and new 450 cam im going to use in this motor. ill more then likly be putting the motor together this weekend if i get the gaskets this week.. im wondering what carb work i will have to do and what octane fuel to use ? i dont want to spend a week scratchin my head,cussing,and taking the bowl off 40 times and wrecking carburetor bowls drilling them out trying to find the best thing to work. i have a ihc carb off of a cobine motor that has the bigger main jet and metering stem in it that would bolt on the upper half of an m carb. i have a few different size venturies to pick from. would this bowl work or am i better off with something different or not changing anything to the stock carb? any help or advice would be greatly helpful! thanks guys!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.