Tractor Pulling Discussion Board |
Re: Re: weld on axle plates
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Killer Red Mater on December 24, 2002 at 07:47:56 from (12.154.3.77):
In Reply to: Re: weld on axle plates posted by Keith on December 23, 2002 at 21:05:49:
I have Daves weld on hubs on my 966. They are very well crafted when you get them. When you are cutting the axle off....... I used a chop saw set up on a stand so it was axle height....then while cutting I turned the axle CONSTANTLY so it wouldnt get a hot spot and pinch the blade. I cut the axles of my 966 in ten minutes per side using this method. Good luck to you and if you have a question drop me a line I try to help all I can. Keith Backer... Oakdale,Ne
Follow Ups:
Home
| Forums
Today's Featured Article -
Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|