A good replacement turbo for a 4430 is a 3lm-33 but is quite a bit smaller that the 3lm-466. I think even with the different manifold you will have to modify it for the turbo to fit. If its a 2.3x2.75 or 2.5x2.75 3lm, you will have to basically raise the bottom part of the flange on the manifold till its level, in other words take the slope out of the lower side and make the flange flat, then you will have to probably modify your water manifold so the compresser housing doesnt hit, then make a different exhaust elbow to get the exhaust out of the turbo and out your original hole. What all is done to your tractor and what classes do you pull? As for a replacement for a TO4, the 3lm-33 would be a good choice, if your wanting something better, you'll have to go to one of the bigger 3lm's. Post back if you have any more questions.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.