I just discovered this thread. Wow, that finish is severe. I would strip those parts and start over.
I do classic car restoration and all my own painting. I've been painting since 1990. My best advice, don't try to save money or skimp on paint/autobody products or tools. With all the manual labor involved it's penny wise and dollar foolish to skimp.
I own two Sata paint guns. I use PPG Acrylic Urethane (single stage on tractor stuff, and car restoration stuff(except the body sheet metal where I use Base/Clear Acrylic urethane. Those enamels are old time. I wouldn't deal with them. Acrylic Urethane will be tougher, have a better finish, if far more resistant to gas, bake fluid and more. One of the keys to restoration is proper metal prep and sealing the metal with a good Epoxy sealer primer like PPG DPLF.
You are breaking a cardinal rule of mixing hardeners and reducers of one company with the paint of another. An unintended chemical reaction is the likely result.
You have proven why it pays to use better products and be consistent in using one product line.
It stinks when you have to start over, but it's also a learning lesson. I think you'll also find if you take my advice, you'll end up with a finish that far exceeds you experience so far. PPG Single Stage Acrylic urethane can be flattened to adjust the gloss level to what you desire also.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.