talked to our basf tech line, they are thinking that the limco hardener is reacting with the iron guard paint when it is atomizing in the gun, causing it to gel up as its applied. it is always best to stay in manufactures paint lines to avoid problems like this. crossing paint lines and different mfr products can cause nothing but problems. at this point, i would strip all the paint off and re-shoot. also, alter your prep proceedure. bodywork, prime and block, wet sand with 400 using warm water and car wash soap ( it rinses clear with no residue) wash again with warm water and car wash soap, immediately blow gun dry. then use a wax and grease remover like prep sol, finyl wash ect, tack rag it, then shoot it. depending on the primer you used, the lacquer thinner could also be causing problems with the primer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.