Posted by Massey farmer on June 07, 2013 at 16:43:08 from (174.226.5.176):
Hey guys, I picked up a airbrush and compressor to play with and try to learn how to do it. I want to start by airbrushing the name of my pulling tractor on the side of it instead of doing the same vinyal lettering like everyone else. Being new to a airbrush I'm not sure where to start. Should I mix the paint with thinner like when I'm using a big gun? Should I even use regular paint or is there a special airbrush paint? I'm up for any advice no matter how basic it seems. I've done quite a bit of painting of cars and tractors so I'm not a beginner just new to airbrushing. I will practice on scrap panels before I dive into the tractor but even if its not perfect that's half the fun.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.