If you are using HVLP there is no easier primer than epoxy to use. As stated use 2 parts primer to 1 catalyst (the catalyst does NOT contain isocyanates). Use no reducer. Use the air pressure at the gun according to the amount stamped on the gun or in the instructions. Do not experiment because HVLP guns vary from about 30 to 50 psi, depending on the manufacturer. You have 3 days to topcoat the Omni version or 7 days to do the expensive version, otherwise you scuff and reapply. It can have surfacer or topcoat applied after 30 minutes. You do need supplied air for the hardener used in urethane, if that is what you are going to use.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.