Posted by MO8N4ME on December 07, 2012 at 08:20:48 from (22.214.171.124):
In Reply to: Grit posted by David G on December 04, 2012 at 15:38:05:
@RTR, You might want to try using 400 grit before your topcoat. It should help your gloss retention. 320 is a little too coarse unless you are hardblocking out imperfections in your metal or primer and you are going to recoat.
Acrylic enamel has less viscosity than the synthetics and can open up your sand scratches a little. You probably won't see it with your eye, but it kills gloss retention. Also the Acrylic enamel reducer has a little more bite than the older synthetic enamel reducer. That bite from the reducer can also react on larger sand scratches.
If you are using urethane you should be using 400 or even 600 as a final sand or you might see sand scratches in your base under your clearcoat. .02
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.