Posted by CNKS on August 20, 2012 at 19:01:43 from (216.144.104.128):
In Reply to: Opinions before I paint posted by David Beasley on August 20, 2012 at 18:48:04:
I can't recommend phosphoric acid on cast as it gets in the pores. You may want to wash it with soap and water if possible and dry it before you get flash rust. It may take several washings, then use repeated applications of wax and grease remover. Either sand the rust off the sheet metal or use a fiber brush on an electric drill, which is much more effective. It will leave deep scratches that can be partially removed with 150-180 grit sandpaper. If you are afraid of rust use Picklex 20, which acts as a preventative and also gets rust in the pits, if any. It will leave some residue that can be sanded off, then use wax and grease remover. Don't use etch, use two coats of epoxy primer followed by sandable surfacer, which will fill the scratches. Absolutely do not use etch on the cast. The amount of phosphoric acid left will combine with the etch and likely will lift the paint. No I don't use ospho, it is too strong, Picklex is a much better and safer product -- but I don't use it on cast either.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.