Posted by bv on March 31, 2014 at 18:57:10 from (22.214.171.124):
Got my 1555 running today, started right up oil pressure at 20 let warm up then it went to 10 when I reved it up to 1500 rpm it started a vibration sounded like rear of engine, hard to tell though, tried another oil gauge amd same thing low pressure, rear sprocket and chain is worn bad so I pulled engine and removed pan and #4 main bearing it was smooth with normal wear, crank looked good but ther is small chunks of metal in pan, needs clutch springs are very loose, pilot bearing was apart, thats enough to vibrate but I'm going to disassemble the whole engine to see where the metal came from, any suggestions and where is the best place to get parts for this tractor? It has 3800 hous and nothing has been done to it. Thanks again.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.