Posted by Ollie Oliver on February 23, 2014 at 20:28:51 from (184.108.40.206):
I have a '52 Oliver 99 4 cyl. I have started the restoration, and am debating to change it over to 12 volt. I have had the starter and generator redone, but to keep it original, they were rebuilt for a 6 volt. My problem is, 6 volt just is not enough to get er to spin. It does have the M and W 5" overbore kit in it, so it's a lot of motor to spin. So, I am thinking of taking the generator and starter back and having them reworked to 12 volt. Will I run into any problems elsewhere?I love originality, but I am tired of hand cranking or pulling it to get it to go. Thanks for any help.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.