Not the original block from this tractor, what about front motor mounting bracket? Phil Heisey would be the man to talk to. He replied to a post above about a Oliver 88 steering seal. Hopefully he will chime in and advise you. I could tell you what I'd do but honestly I'd be quessing. I do have my engine out of my 30 right now and I will just re-insall shims where they came from when it goes back in making sure things are not binding as I do so. You may have to adjust # of shims depending on how things line up as engine goes back in. Do you have a manual? Not sure it's covered in there. I will check and get back to you if someone more knowledgable doesn't step up and help you out. Rocko.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.