Posted by Rob Mo. on November 07, 2012 at 15:18:07 from (220.127.116.11):
Early in the summer I upgraded to a hydraulic setup. After everything was installed & tightened down I was eager to hook on to a tandem disc. After hooking to the hydraulic lift cylinder, it only moved stoked the cylinder 1" & stopped. I checked the fluid & it is nearly empty.
The fluid is dumping into the transmission somewhere, however I am not for certian. I am going to pull the unit out here in the next couple weeks & I am wanting some imput on what & where to look for. In theory, If I can get a power shaft, cut it down to where the splines that drive the pump & turn the shaft down to fit in a 1/2" drill. My thought is that if I can get the pump to turn fast enough to build up pressure, it should be able to spew out fluid where ever it is coming from.
Any thoughts or imput on how to test this system out of the tractor would be helpful.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.