I know the inlet where it slides on the exhaust manifold is 3 7/16" or 3 1/2". Do you want one that looks similar or exact original? The original should have two welded rings around the center of the muffler. If you can"t find an original I found one in the A&I parts book listed under an 1100 Massey diesel. I"m not sure if its a Nelson or Stanley. We put it on our 990 and it looks and sounds good. If you want that part# send me an email. For some reason the site won"t upload my photos, I can email them too if you want. John
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.