Posted by P I Pete on September 09, 2012 at 14:43:03 from (184.108.40.206):
I bought a super 55 a couple mos. ago, engine was stuck, cracked sleeve and lots of rust 3 1/2" bore 1 hole kit is $250 easy choice, do all four. 3 5/8" or 3 3/4" if I go with the 3 3/4" will I gain any H.P with the larger bore? over the 3 5/8 Next question is will I have any trouble keeping it cool? It is a non pressure system. Also I am looking for a top link for 3 point and a 3 point 2 bottom plow in So Mn. thanks
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.