OK doing more digging. here is the text from the link i gave: (that mentions a pilot bushing)
Please read complete application information including serial number break.---9", 10 SPLINES. KIT CONTAINS: CLUTCH COVER, CLUTCH DISC, RELEASE BEARING, PILOT BEARING & ALIGNMENT TOOL. NAA and JUBILEE USED A PILOT BUSHING THAT IS NOT INCLUDED.
here is the text from the link UD gve me:
Description: Fits 8N, 9N, 2N, NAA, Jubilee, 600, 620, 630, 640, 650, 660, 700, 800, 900. Kit contains 9 inch 10-spline spring drive disc, 9 inch single pressure plate, pilot and release bearings, includes pilot tool.
they both seem to have the same parts but im still confused why one says i need a pilot bushing and the other does not mention it at all. confusing to say the least.
but if the folks here with much more expirience say UD's link shows all the parts i need i'll go with it. thanks again.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.