Posted by KenKeith on February 06, 2014 at 15:23:23 from (97.85.193.199):
In Reply to: 8N Ford posted by KenKeith on February 05, 2014 at 06:09:48:
I was hoping a Jube engine would fit, as I would like to add a few more horsepower to the tractor, and there is a very limited amount I can do to the stock 8N engine to get more out of it, short of a turbocharger or some such, and I really don't want to spend that kind of money. The engine is in need of an overhaul. Other than spending an outrageous fortune on a FUNK kit and then another fortune on a flathead V-8, Im not really sure what I want to do. I have also contemplated trying to swap in an old Falcon 144, 170, or 200 cubic inch inline 6, but that would probably put me right up against the same cost as the other conversion. Anyone have any ideas or have done any successful swaps? Other than ruining a good tractor by putting another brand of engine in it?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.