Posted by ASEguy on December 07, 2013 at 05:04:06 from (24.207.160.166):
In Reply to: OT 2000 Ranger posted by reomack on December 06, 2013 at 13:59:45:
I would not assume you don't have a vacuum leak with those codes. You may also have two issues. If the IAC motor is stuck open it will cause an inability to idle. A diagnostic tool would read IAC steps and from that you could determine whether it is sticking. You can also remove and clean the IAC motor pintle and seat for carbon build-up. At that time, since the engine would be cold, make sure the pintle is very close to it's seat. If it seems like it's stuck far from it's seat clean it or replace it but it has to move. You need to rule out issues brought up by Hobo, Matt and 4play as well. I would like to know if this driveability issue happens with every start of the truck or is intermittent. You said EGR is not stuck open, but EGR may need to be verified. If all checks well and is clean get it smoke tested. Hope this helps. Gerard
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Magic Moments - by Tyler J. Woods. Magic moments don’t just happen. You have to help them along. This morning, I got up early. It is my day off from my regular workweek and I had a lot of things to do. It’s fall, and with winter coming on, there is a lot of work to do before weather closes in.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
