Posted by tn.jed on November 09, 2013 at 11:09:05 from (50.109.5.91):
I am going to be changing my exhaust over soon. Years ago I got a brand new exhaust from the local farm store. I was workin on a brush pile and it beat that exhaust up pretty bad. I replaced it with one of those silly little vertical stacks. Mmmmm the fresh scent of burning fuel what a wonderful thing. Well not so bad at first but now I am rethinking things. With this j pipe for the vertical exhaust it loops down about 9 inches from the manifold then tuns back up. The running board on the tractor is about 9 inches lower than the manifold. I am thinking about cutting the j pipe mid bend where it is at its s lowest point then putting a straight pipe or with a slight bend to get around the bell then mounting a Walker Quiet flow for a Honda under the running board with a turn down. It all looks like it will line up pretty well. The muffler will is just as wide as the running board and only hangs down 4 inches which puts it higher than the original muffler that got beat up. I have seen where some people have done similar things, is there anyone with any advice?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that ‘quick look over’ before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.