Posted by WW2N on October 27, 2013 at 17:25:38 from (64.187.67.48):
In Reply to: Fender Rivets posted by Old 8 Guy on October 27, 2013 at 15:44:20:
Most ask how to take them out. I have replaced rivets with carriage bolts, but here's what you do. First did you get a good clean hole nice and round so you wont clench (bend) it when you drive it. Did you get a mild steel or aluminum rivet? I would say at the Ford plant they were put in with a rivet press and that is how I would do it. I can tell you how to do it at home but if its a steel rivet it will take some some real power to drive it. You will need a air tool like you cut tail pipe an muffler off with and convex driver attachment, Flat driver will work, and a bucking bar. Its simple if you have that stuff. Farmer way is messy and crude you will need a large ball peen hammer. Post back if you want to do it at home but a press is best. I have driven thousands (really) in airplanes, helos,& boats and iron. Even I would have it pressed in.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
