Posted by soundguy on September 11, 2013 at 08:13:17 from (108.112.100.152):
In Reply to: 8n Steering posted by Patsdeere on September 10, 2013 at 21:43:45:
As ud said. it's a numbers game.
match center of rotation on the dual and single sectro to mid travel on the ballnut.
also.. have your sector backlash studs loose to assemble.. then adjust double sector.. then single sector.
do not over tighten them or it will be hard to turn.
lastly. if you had a bad thrust bearing and did not repalce it.. you will run into weird backlash issues due to thrust paly.. and it will make for hard / sloppy steering. also there is a bushing under the steering wheel that centers the wormshaft. this will cause issues with backlash at the double sector to ballnut as well as the shaft does not center.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.