Posted by Matt Yellen on September 03, 2013 at 14:55:03 from (137.118.152.252):
The issue I am having is with lifting my 3 point hydraulics. When I move my control lever to the up position with the PTO engaged my 3 point arms move up very slowly, if they have no load on them. They will not reach their max travel.
If I have a load on them, they will not move at all.
Today I was playing with the draft control lever and I found that if I slowly move it to the down (forward) position, the 3 point arms will lift all the way up, even with my load. If I go to far forward with the draft control lever, the arms fall back down.
I can control the height with a mix of the draft lever and the hydraulic control lever. The draft lever will not stay in any position other than up or down (forward), which means my 3 point hydraulics aren't working for me. What is wrong and what do I need to do to fix it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.