Posted by Dell (WA) on August 25, 2013 at 21:34:25 from (71.212.61.186):
In Reply to: Re-routing plug wires posted by BrianLivingstone on August 25, 2013 at 17:16:18:
Brian.........yep, yer weird 4-nipple frontmount dizzy had a "tube" that the sparkie wires were "fished" thru. It was a mechanical protective scheme to keep the sparkie wires semi-contained. When Ford went to the 5-nipple sidemount on the later 4-speed 8N, there is just ONE grommet on a bracket that all 4-wires went thru.
More importantly, use old fashioned COPPER-CORE (cut to length) 'stedda' modern string sparkie wire. (new sparkie wires with GOOD insulation, $15, cheap)
When I replaced the sparkie wires on my eazy starting 6-volt 52 8N, I bought a set fer HOT-ROD Pontiac V-8 that had right-angle rubber booties to fit under the gastank. My 9-yr son helped me replace them. NO soldering necessary. ........Dell, yer self-appointed sparkie-meister
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.