Posted by TheOldHokie on August 25, 2013 at 15:44:42 from (71.176.183.238):
In Reply to: Front axle pin posted by 54NAA on August 25, 2013 at 14:38:32:
54NAA said: (quoted from post at 17:38:32 08/25/13) My NAA has a one piece, non threaded pin. nothing threaded on the axle support. the axle does slide forward and aft when the radius rods are adjusted according to front wheel spacing.
After checking the parts manual I stand corrected. The NAA used a different axle support but the same pin and spacer setup as the 8N. The threaded pin wasn't introduced until the Hundred series.
Looks like you need a replacement pin (NAA-3126A) and bushing (2N-3039). The NAA used spacers like the 8N but unlike the 8N they were all the thinner (.090) 8N-3027 spacers and were placed front and rear as required - roughly three needed according to the parts catalog. The radius rods were attached to the center axle section just like the 8N and did not move when the spacing was adjusted. If the radius rods are not attached to the center axle the tractor is likely farmerized using 9N/2N parts. I'm sure Don B would know exactly what combinations might have been used.
TOH
This post was edited by TheOldHokie at 15:47:57 08/25/13 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.