Posted by delvaughn on June 30, 2013 at 13:29:40 from (70.198.129.160):
In Reply to: OT Chevy 2.2 eng posted by delvaughn on June 29, 2013 at 15:40:29:
Thanks for the ideas. The plug wires are right, I put numbers on the wire ends from left to right of eng before pulling them an I checked this twice. The push rods was placed on the bench in the order they came out of the old head an went back one at a time along with the rocker arms. All the wires an vacume lines are on. They can only go an plug into there right spots due to the size of lines an plug ends male an female. The eng cranks normal but when it fires it will kick back an sometimes fire comes out. I will try backing off the rocker nuts a turn or so an see what happens. Before I replaced the head number 3 cyc would get water in it after setting. After about 4 months the eng stared running like crap. I pulled the head an found a crack in #3 from spark plug hole to excaust side of head. Thanks again for the "try this" ideas.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.