I set several tall & heavy poles for my pole barn using my 8N. I got a 12"2x8 and cut a v notch in the end. I then used a 50" rope and hooked it at one end under the rear end of the tractor and the other end about 3/4 up the pole with one end of the pole by the hole and the other end set up on blocks as high as I could lift it. I put the 2x8 in the middle of the rope slanted towards the pole. I then drove the tractor forwards pulling the pole up. It helps to have someone keep the 2x8 straight in line with the rope. It also helps if the hole has a slanted side to keep the pole lined up.
This post was edited by Danny in CO at 10:07:18 06/13/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.