1952 model 8N Ford tractors have a fillister head screw (1/4X24?) in the steering column about 2" beneath the steering wheel.
You can fill here if you use 90W and fill from a squeeze bottle.
I usually remove the steering wheel and fill until I cover the top bearing to lube it, then replace the plug and wheel. It may slobber for awhile. Allow it to drain a bit from the screw hole if that bothers you.
If you use cornhead grease, you can remove the screw to act as an air bleed or simly fill until you see grease begin to come out beneath the steering wheel. It helps to remove the wheel.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.