Posted by it me again on May 08, 2013 at 06:55:21 from (198.204.212.135):
In Reply to: oil filter leak posted by steve43 on May 08, 2013 at 06:26:01:
take it to part cleaner.. clean off all junk you add .. then let dry .. then back to part cleaner again and a good wire brush the a toothbrush where the rubber go then let dry then paint let dry.. then drain oil canister filter take it off and clean it out really good the clean two more then drain out then when dry paint then back to step one buy a new oil filter or new gasket then put new filter in and put cap on with gasket put on tight it down. it bitxxx hard sometime and that what i would do
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.