Posted by Larry Wallace on April 11, 2013 at 20:01:08 from (67.142.181.25):
In Reply to: 8N Ford tractor posted by Torri on April 11, 2013 at 17:15:16:
Thank you Torri!
You saved me the trouble of asking the very same question I"ve been trying to ask. For the last two days Chris here at YT has been working hard trying to get me so I can post again.
The exhaust manifold gasket on my 8N needs replaced. YT fixed me up with the gaskets. The aft exhaust manifold stud on my 8N came out with the nut. The nut is either frozen, cross-threaded, or more likely, somebody used a metric nut since I needed a 15 or 16 mm socket to remove it. Anyway, I decided to replace the stud and you helped provide the answer to the same question I had. Thank you.
And thanks much to Soundguy and Dell for the technical guidance.
Forgive me for hi-jacking your post. Now I may need some training on how to upload pictures.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.