Posted by mhb@ufe on April 10, 2013 at 04:51:01 from (24.39.22.34):
In Reply to: Starter Ring posted by Waterworth Farm on April 09, 2013 at 19:03:53:
To remove the ring gear I stand the flywheel up in a vise and cut the ring gear with a hacksaw as far as I can without cutting into the flywheel and than use a chisel to split the ring gear. To install the ring gear I hang it on a prybar and go around it with a torch until it juast starts glowing red then drop it on with a pair of pliers. I then use the pliers to spin the ring gear until it shrinks onto the flywheel. This method has been used at the dealership I work at since before I started here in 1979.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.