Posted by sandbag3 on March 16, 2013 at 23:05:49 from (67.233.202.86):
Just got my 9N back from being overhauled and the mechanic had it almost a year outside his shop and all the ignition wiring to the 12 V key switch is rusted out. The engine was running while I was bushhogging when it just stopped. I moved the battery terminals and it started again. After replacing the battery wires, a wire from the solenoid side where the battery is hooked up came off and I think it was attached to the key switch. All the terminals on the key switch are coroded and I will have to replace it and them. Anyway the tractor won"t start but there is power going to solenoid but nothing to the switch.
Is there a diagram that demonstrates where the wires go on the switch? I guess I can get a standard key switch from Auto Zone that has an ACC on it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Crank Start a Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.