Posted by TheOldHokie on February 20, 2013 at 10:29:13 from (184.108.40.206):
In Reply to: What drill size posted by BMACK518N on February 20, 2013 at 10:05:48:
BMACK518N said: (quoted from post at 14:05:48 02/20/13) Study up, more to grease zerk's than you think. Even metric sizes now.
Sometimes the advice you get here isn't even worth what you pay for it which is zero. JC also needs to do some studying on thread/pipe sizes. The pitch diameter of a 1/4" NPT male pipe thread is .447 at the first thread (small end) of the taper. Good luck screwing that into a 1/4 tapped hole of any pitch :roll:
This post was edited by TheOldHokie at 10:30:18 02/20/13.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.