Posted by Farmerhr on February 18, 2013 at 21:43:07 from (22.214.171.124):
About three winters ago,I decided that the leak in the rear axles needed to be repaired. I used the method recommended by John Smith. It really worked well. I have three years on the repair and absolutely no oil leakage. While I was doing the job, I noticed the axle bearings had some pits. Decided to replace them. The part number was 2N-4221 for the cones and 9N-4222 for the cup. The cones were about $60.00 each from this site. I was looking at the Timken web site and noticed that a 3780 bearing is the same as the Ford bearing 2N-4221 except there is not a radius on the small end of the cone. It takes the same cup. The price for a 3780 bearing was about $14.00. I ordered a pair and used them. I felt confident that they were worth a try since the seal 8N-4284 that goes against them is now made from a rubber rather than cork like the orginal. Also, the seal on the other end goes against the hub which has no radius cut it it. As suggested by John Smith, I used some blue Permatex compound on both ends of the seal. So far everything is working fine. I will keep our team posted how this works out over the years. Thank you for letting me share my experience with this great web site.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.