Posted by xj43 on January 24, 2013 at 05:54:16 from (220.127.116.11):
In Reply to: 8N sleeves posted by billy boy2 on January 23, 2013 at 15:52:44:
I just went through the same ordeal. Mt sleeves were removed and had oversize pistons in the bare block. The pistons were stamped .083 on top. there was a pretty good ridge around the top of the bore were the lip of the sleeve used to set. Mine was worn bad enough that I had to put custom .125 sleeves from melling back in. It turned out real nice but it wasn't cheap
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.