Posted by Dell (WA) on January 10, 2013 at 09:36:08 from (220.127.116.11):
In Reply to: 8N pto shaft posted by mjsnodgrass on January 10, 2013 at 00:54:30:
mjsnodgrass.........other than puttin' a tunafish can under yer leaky PTO to catch the drips, yer goin' to haffta SAW yer PTO out with electric sabersaw. Then FLUSH with kerosine or diesel to remove the chips. Then you will haffta drop yer flat hydraulic pump base to remove the remaining stub of the PTO. Flush again. Replace with modern 1-3/8" PTO shaft which contains new 4-bolt seal. Refill with 5-gals of M2C-134D hydro-tranny oil. Twisted PTO is caused by brushhoggin' without using an ORC. (over running coupler) naughty-naughty$$$
I saw a sign the other day, Harley's don't leak, they just mark their spot. ........Dell
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.