There are two types of Bendix, the new style on the right and the old-original style on the left.
You probably have the old style with a spring.
To remove the Bendix you have to compress the Bendix back toward the start and remove the pin #20.
I use two bar clamps place around the starter and over the end of the Bendix. A third clamp will hold the two clamps on the Bendix if they start to slide off. You only need to push the Bendix back about 1/8". Then you can tap the pin out with a drift. Once the pin is out, remove the clamps and the Bendix will slide off. Reverse to install.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.