OK guys, I'll try to find an oem resistor. The owner of this tractor had put a jumper across the terminals of the resistor when it burned out so he could feed his critters, but the points didn't like it and eventually gave up. That's when he asked me to convert it to 12V. I've worked on the engines of these little tractors quite a bit, but never did a 12V conversion on one.
I guess I should ask; What is the voltage I should be shoot'n for when measured at the terminal on top the coil? It's my understanding that the original 6 volt system was reduced to near 4 volts at the points by the oem resistor. Would that be a bit too much to expect on a 12 volt system.
I found some 12 volt conversion information on the 'net' that showed a second resistor in series with the oem resistor but it didn't say whether the coil was still 6V or had been changed to 12V.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.