Posted by Dell (WA) on December 09, 2012 at 22:53:48 from (71.217.26.122):
In Reply to: 9N Points posted by Connor on December 09, 2012 at 12:46:00:
Conner........you do know ittza 2-bolt, 15-min job to remove the weird 4-nipple frontmount dizzy and change the points (0.015") on the kitchen table, don't you??? Just un-snapple yer capple and letter dangle. Installation is a reversal of the removal ...except... finger start the 2-bolts and install the rotor. Rotate the rotor until the OFF-SET drive tang fits into the camshaft OFF-SET drive slot. Now tighten yer 2-bolts and re-snapple yer capple. Simple, eh?
The OFF-SET drive scheme means you can never install yer 2-bolt dizzy outta time.
REMEMBER to "polish" the INVISIBLE corrosion from between the points (0.015") after installation. Me? I clamp a clean $1-bill between the points (0.015") and pull. Iff'n yer really cheap, tear a strip from HEAVY brown paper grocery sack and use that.
Surprizingly enuff, points CORRODE when OPEN. (oxygen in air you know) Closed points do NOT corrode. Howsomevers, closed points will MELT the cheap points plastic bumper iff'n you leave the weaksister ignition switch ON.
FYI.........yer weaksister ignition switch is the cause of most 9N run problems. It goes BAD innna 'bout 15-mins just as you complain. After it cools down (30-mins) you can re-start yer 9N and it will run fer about 15-mins again. ...also... yer carb has about 5-mins of gas in the bowl. A BAD condenser usually runs fer about 1-min before weak sparkies cause engine stops.
A BAD squarecan ignition coil runs fer about 1-hr before the insulative tar melts and causes engine to stop. ........Dell, yer self-appointed sparkie-meister
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.