Posted by Richard from SE AZ on November 14, 2012 at 14:05:42 from (206.169.89.203):
I have been looking for a front mount N motor for a couple of years. None to be had anywhere close to AZ. I found one on the East coast but shipping was hard to believe.Even from as close as Idaho shipping is high. I bare block 80 miles from where I live that I could go get was $500. I couldn't even find anyone that would trade for a side mount in good shape.Sooo, I guess I will use the motor that came with the tractor. I bought it as stuck but the problem was a piece of starter drive stuck between the housing and the ring gear. I didn't want to use it cuz it had been cracked and JB welded. I will clean up the old JB and redo it. I need the tractor so I can put a loader on it(I already have the loader) for occasional use. Prices for old fords around here are PRETTY high.The tractor was really cobbled up.Good winter project. Gonna start after Thanksgiving.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.