Posted by kylemorley on November 09, 2012 at 12:11:47 from (96.61.82.64):
Got some Dorman freeze plugs at the local auto parts and removed the old ones, cleaned up the seats really nice with a wire brush on my drill, only to find that the plugs don't even begin to go in the holes - I pound them awhile, they seem to be going in, then when I stop pounding they fall out.
I cleaned up the edges a bit with emery paper but am afraid if I remove too much meat they won't fit well and will leak.
So I guess my question is, how tight should they fit before they get flattened? Should they take serious pounding to get into their seat, or should they go in fairly easily since the flattening is what makes the seal?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.