Posted by Kenster on November 02, 2012 at 11:10:58 from (166.147.72.148):
Sorry to start a new thread for this but have not been able to get any replies from previous post.
I'm trying to get my tractor back together. I'm installing a new fan and water pump. There is a back plate with an off set 'ear' that was already on the tractor and a new one came with the new pump. I don't see any need for this back plate since I have an alternator that does not require this plate to mount. Does this plate serve any purpose other than to mount an old generator? If I don't use the plate, I will have an extra eighth inch clearance between the fan blades and the radiator overflow tube. right now the blades are barely rubbing the tube.
If I don't use the plate, I just use a regular "smiley face" gasket between the pump and block?
Getting an answer to this one question has been holding me up. I can't find a single reference to this on Google, other than a listing for the part.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.