Posted by Farmerhr on October 28, 2012 at 21:38:37 from (184.108.40.206):
I am rebuilding a 1948 8N with a front mount distributor and it has been converter to 12 volts. When I took the oil pan off, there was the remains of a part in the oil pan. The part appeared to have been there for quite some time. The part was about 2 inches in diameter, has a about a 1 5/8 D shaped hole. The part is about .080 inches thick. A small section appears to been broken off. The tractor ran fine before the tear down except it was burning considerable oil. I have not been able to identify the part by looking through the parts manual. Does any one have any idea where this part came from and what it is called ? Thank You !
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.